Intermec CK3 Hard Reset

Before you give your handset to repair shop or buy new handset, please try the following procedure to repair your device. First charge your battery more then 70%, backup your important data like phone-book, message, email, images and settings and in most cases take out SIM card and SD card. After doing hard reset not possible to recover your data, so online backup is always important. For all of your data, a backup should be done on a external device, hard drive, raid system media or SD card. 

 

How to Hard Reset Intermec CK3

 

Warm Boot

Press and hold the Power button until the screen goes blank. RAM is clear, no settings or applications are lost.

 

Cold Boot

If the preferred reset method does not restore the CK3, you must remove the battery – there is a small black round button at the top of the battery compartment  of the unit. Press and hold that button for about 3 seconds and then re-insert the battery; do not touch any key. The unit will turn itself on, and will reset. No settings, no files or  applications are lost.

 

Clean Boot (without the CK3_Automated_CleanBootPatch.cab)

To clean boot the CK3, you must remove the battery – there is a small black round button at the top of the battery compartment  of the unit. Press and hold that button for about 1 seconds and then re-insert the battery. As soon as you insert the battery, press and hold the Power button (yellow button)  until the screen asks you if you want to clean boot – press the button indicated on screen to clean boot. (scanner button , or press the trigger on the scan handle will accept the clean boot) RAM is clear, all settings are removed, all applications are removed if not part of the SSPB folder.

 

Clean Boot (with the CK3_Automated_CleanBootPatch.cab, unit that has the patch install will have a bootloader of 3.45.26.0041a, warm boot to unit to see the Bootloader version)

To clean boot the CK3, you must remove the battery – there is a small black round button at the top of the battery compartment of the unit. Press and hold that button for about 1 seconds and then re-insert the battery. As soon as you insert the battery, press and hold the Power  and the PTT button  (to the right of the scan button) until the screen asks you if you want to clean boot – press the button indicated on screen to clean boot. (scanner button , or press the trigger on the scan handle will accept the clean boot) RAM is clear, all settings are removed, all applications are removed if not part of the SSPB folder.